Research on incremental forming simulation based on an improved constitutive model

Abstract

The incremental sheet metal forming process, characterized by the step-by-step deformation of sheet metal using a simple die, is classified as a type of plastic deformation technology. This method allows for the formation of complex-shaped parts even without the use of a specialized die. Its notable characteristic lies in its low forming load and high flexibility. To accurately forecast finite element simulation outcomes for the incremental sheet forming of 2024-O aluminum alloy sheets, constructing a precise constitutive model is essential. Typically, the uniform strain range in traditional unidirectional tensile tests does not surpass 0.3, primarily due to the necking phenomenon. This limitation hampers the accurate prediction of the actual large plastic deformation process. To address this issue, a theoretical model describing the stress-strain relationship in metal plastic deformation processes is developed using crystal plasticity theory. The constitutive model for the forming of 2024-O aluminum alloy is then constructed by adjusting the hardening coefficient and hardening index. Utilizing the improved constitutive model, the incremental sheet forming process is simulated using ABAQUS software. Upon comparison with experimental results, it is observed that the Thickness Average Absolute Relative Errors (TAARE) of the adjusted constitutive model at forming angles of 60°, 55°, and 50° are 0.414%, 0.467%, and 0.256%, and The Thickness Root Mean Square Errors (TRMSE) are determined as 0.0121, 0.0116, and 0.0094, respectively. These results indicate that the constitutive model and parameters established in this study can adequately capture the mechanical behavior of 2024-O aluminum alloy during the incremental sheet forming process.