Abstract

The electromagnetic incremental forming (EMIF) method is used for tube forming process. Suitable 2D FE models are designed to predict the forming process with a moving coil. In comparison with experimental values, simulation method can obtain accurate results. Then, effect factors named overlapping ration of adjacent discharge positions, discharge voltage, forming sequence and die dimension on tube homogeneous deformation are discussed. The result demonstrates that it is feasible to produce long-straight wall tubes using a small coil by electromagnetic incremental tube bulging.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.