Abstract
Sanding is a very important process in MDF production. In this study, abrasive belts (P60 and P120) and MDF were used to conduct sanding experiments, and mass variation, surface morphology, and surface roughness of the abrasive belts were measured to analyze the failure process of the utilized abrasive belts. It is found that the mass of the abrasive belt mainly increased in the sanding process. The increase range of P60 is mainly within the scope of 0~0.02 g, while for P120, the mass change mostly fluctuates within 0~0.01 g. The surface roughness (Sa and Sku) of abrasive belts presents a down-and-up trend as sanding times increase, and Sa and Sku of P60 are both larger than those of P120. Wood fibers with adhesive blocked the space among grits and led to a “grits gathering” phenomenon. When the area of “grits gathering” is larger, it forms an abrasive belt “blocking”. Grit wear (dropping-off, fracture) and “blocking” constitute the two predominant patterns of the failure mechanism. This study is helpful to further improve wood-material-sanding theories, provide insights to investigate wear forms of other abrasive belts, and determine and extend the life of abrasive belts.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.