Research on EOR for ultralow interfacial tension foam in high-temperature and high-salinity reservoirs: flooding simulation and application in Shengli Oilfield

Abstract

For high temperature and high salinity reservoirs, the foam formulation system is required to have better foaming capacity and foam stability under formation conditions in tertiary EOR. In order to obtain a new foam agent suitable for this type of oil reservoir, through the compounding and testing of 7 common oilfield foam chemical agents, 15 formulated foam agents are tested and screened. Then the foam displacement experiment of the dual sand packs model was established to simulate the new foam flooding process. The production dynamic of the high-permeability sand pack and the low-permeability sand pack was captured and analyzed, and EOR mechanism of the foam system in the heterogeneous reservoir was clarified. The experimental results show that the formulation of B4(anionic & nonionic combined surfactant) & FSN100(fluorinated surfactant) with a mass proportion of 2:3 (BF23) has the best performance in terms of foaming properties, low interfacial tension reduction, and oil washing efficiency. Furthermore, BF23 foam injection greatly increased the recovery factor from 36.7% to 61.6%, clearly displacing the remaining oil in the low-permeability pack. Finally, the new foam agent solution used in Shenger block of Shengli Oilfield shows its good value for enhanced oil recovery.