Abstract
the aid of commercially available software MSC.SuperForm, a 3-D finite element model has been established to simulate the rolling process of steel tubes on the stretch reducing mill (SRM) with group centralized differential drive in certain factories. A special effort was made to analyze the fluctuation of transverse wall thickness uniformity. It was found that the wall thickness of each stand was accumulated in the original pass 50°~60° along the circumferential direction, which caused the formation of the inner hexagon defects and worsen. In view of this, this paper proposes a modified roll pass design method which uses the interactive technology of CAD graph curve and MATLAB equation. By means of decreasing the lateral curvature of roll pass contour curve to enlarge the contact length between the tube and groove, also the rolling process using the new pass system were simulated and analyzed. The results indicate that the design of such polygonal roll pass can be effective in improving the inner hexagon defects.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
