Abstract
There are large quantities of heat is wasted in the producting process of cylinder drop stamping part, it is necessary to recycle the heat from the perspective of environmental protection. In this paper the waste heat recovery system that based on heating pump were analyzed, building up cylinder drop stamping normalizing temperature curve and observed metallographic microstructure of the samples at different temperatures. Rapid establishment of geometric model through the use of Pro/Engineer, application of Pro/Mechnica analog normalizing temperature curve, observed the cross-section temperature field nephogram. Based on the analysis, been established by virtual prototype thermal analogue in the Pro/Mechnica with the measured cooling process is consistent. waste heat recovery system which is used in the production of cylinder drop stamping part is effective.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
