Abstract
The box body drawing process is prone to breakage defect. Using finite element analysis software Dynaform5.7, the box part in deep drawing process was simulated. The friction coefficient was observed to change between sheet metal and die. Analysis of sheet metal forming limit and wall thickness distribution,therefore came out with the following conclusion:box deep drawing is affected by the lubrication , when the friction coefficient is lower than 0.17, Lubrication can effectively prevent the box shaped parts from cracks. At the same time, the research still is developing a new drawing.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.