Abstract

Bidirectional output fiber laser oscillators can realize two high-power laser outputs employing only a single-laser resonant cavity and hold the advantages of being low cost and of compact size. However, like other fiber lasers, their power improvement is limited by transverse mode instability (TMI). To achieve higher power output, in this paper, the characteristics and corresponding suppression method of the TMI in bidirectional output fiber laser oscillators were investigated for the first time. Firstly, the TMI threshold was obtained when the fiber laser oscillator was pumped by 976 nm LDs and 981 nm LDs, separately, and the difference between the two pumping conditions was researched in detail. After that, a comparison study between the bidirectional and unidirectional output fiber laser oscillators pumped by 981 nm LDs was carried out. In the experiment, the effect of pump distribution on the TMI threshold was also considered. The results show that the TMI threshold of the bidirectional-output laser pumped by 981 nm LDs is much higher than that pump by 976 nm LDs, which means that the effective TMI suppression methods in the unidirectional output laser are also applicable in the bidirectional output laser. In addition, it is found that the TMI threshold of a bidirectional output fiber laser is much lower than that of a unidirectional output fiber laser.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.