Research of Crack Defect Detection in Metal Pipes Based on Microwave Antenna Array

Abstract

This study evaluates the feasibility of using antenna array to detect crack defects in metal pipes. Antenna arrays are set at the port of a metal pipe in radial direction, and the microwave signal can be effectively coupled into the metal pipe. It can produce orbital angular momentum (OAM) waves. The cracks in the pipe will change the microwave transmission characteristics, and they can be inspected by time domain reflectometry (TDR) of vector network analyzer (VNA). By studying the transmission characteristics of current on the inner surface of the metal pipe, the feasibility of linearly polarized TE11 mode microwaves for crack inspection was preliminarily verified. Three galvanized metal pipes with an inner diameter of 8 cm and a total length of about 270 cm were used in the experiment. Axial slits and circumferential slits were used to simulate the crack, respectively. The slits penetrated the pipe wall with a breach of approximately 10 cm × 0.7 cm . The experimental results demonstrated that the radial direction antenna array can detect both the axial slit and circumferential slit through TDR and standing wave ratio (SWR) at the port, especially effective for the axial slit. It provides a new inspection method for metal pipe defect evaluation.