Research of a fibrous layer at refining in the refiners

Abstract

A subject of research – a fibrous layer in the refiners at refining. By means of the tension compression chart it is shown that parameters of a fibrous layer are adequately described by Maxwell-Thompson’s model for liquid friction and the Hooke model for boundary friction of a plate. Deborah’s number of a fibrous layer is also investigated. Deborah’s number of a fibrous layer at refining changes in the range from 7 to 2.1·106 and depends on a nature and concentration of the refining material, the angle of knife crossing, the frequency of rotation of rotor and width of the platform of contact. For decrease in power consumption at refining both chips and pulp of high concentration it is recommended to increase the speed of sliding of knife of rotor along stator knife. It is possible to reach by increase in frequency of rotation of rotor and by decrease of an angle of crossing of knife. At refining of pulp of low concentration for decrease in power consumption of refining it is recommended to reduce the frequency of rotation of rotor and to increase the angle of crossing of knife of rotor and stator. At the high density of contact of plate knife in the range from 5 to 106 of Deborah number the deformation component of friction coefficient decreases together with power consumption of refining process.