Abstract
In this paper, the machining properties (including planning, sanding, drilling, shaping, mortising and crosscutting) of Magnoliaceae glanca Blume, compared with Castanopsis hystrix, were tested. Their properties were conducted according to the criteria ASTM D1666-87 and the test on crosscutting was referred to the method established by New Zealand Forest Research Institute. The results show as follow: The machining properties of Magnoliaceae glanca Blume and Castanopsis hystrix in the planning, sanding, boring, shaping and crosscutting all show excellent, but the mortising property, a bit poor, shows good. The comprehensive properties of Magnoliaceae glanca Blume are better than Castanopsis hystrix.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
