Reproduction of air velocity in the entrance region of the test pipe in a wind tunnel

Abstract

The airflow development in the pipe, in the entrance region of the wind tunnel located in the Lithuanian Energy Institute, the laboratory of Heat Equipment Research and Testing is investigated to analyze the conditions for the reproduction of air velocity values. The analysis is performed to reveal undeveloped flow conditions where the calibration of the devices is usually made, the entrance region of the pipes, or free stream from the nozzles. In this study, different flow regimes have been investigated using different air velocity measurement methods. Experimental and numerical results clearly show the features of the developing flow. They both demonstrate the stable core of the velocity profile up to 5 D in the pipe and ≤1 D from the entrance into the free stream in the testing chamber. Ultrasonic anemometer (UA) installed in the aerodynamic test facility shows reliable and highly comparable results with another non-intrusive device – laser Doppler velocimeter (LDA) in a range of velocities from 0.05 m/s up to 30 m/s. UA integrated into the wind tunnel is not found to be used for metrological issues for air velocity. Due to the fast response, they both enabled to analyze fluctuations in the flow. Local vortices identified in the flow have influenced the low-frequency fluctuations and the scatter of measurement results. Moreover, high-frequency fluctuations found in the flow originated from the flow turbulence and might be due to the electronic or acoustic noise. The stabilization of the entrance region in the pipe influences the mean value of air velocity, the transversal distribution of velocity and the development of axial velocity in different test sections of the pipe in a wind tunnel. Along with the recirculation zones in cavities of ultrasonic transducers, these factors are essential that make an impact on the reproduction of air velocity value.