Repolishing in situ eroded CAD/CAM restorative materials and human enamel

Abstract

This study aimed to evaluate the effects of repolishing on the surface microhardness (SMH), color change (ΔE), and translucency parameter (TP) of previously in situ eroded computer-aided design/computer-aided manufacturing (CAD/CAM) restorative materials and human enamel. Each of 8 volunteers wore an intraoral appliance containing 3 CAD/CAM restorative material specimens (IPS e.max CAD lithium disilicate ceramic, Lava Ultimate hybrid ceramic, and poly (methyl methacrylate) (PMMA) block) and 1 human enamel specimen. The specimens were subjected to in situ erosion cycles by rinsing with a cola drink (4 × 5 min/day) for 14 days. After erosion, the specimens were polished with a silicone polishing system (Ceramister, Shofu Inc, Kyoto, Japan). The SMH and color of the specimens were determined at baseline (T1), after erosion (T2), and after repolishing (T3). The ΔE and TP values of the specimens were further calculated. The data were statistically analyzed using repeated-measures analysis of variance (ANOVA) and Bonferroni's test (α = 0.05). After erosion, a decrease in the SMH of the restorative materials and enamel was observed (all P < 0.001), and a decrease in the TP of the enamel was observed (P = 0.016). The ΔE values of the enamel (ΔE = 7.32) and Lava Ultimate (ΔE = 3.19) exceeded the clinically unacceptable threshold after erosion. After repolishing, the SMH of the restorative materials and enamel at T3 was significantly higher than that at T2 (all P < 0.001). No significant difference was found in the TP and ΔE values of the restorative materials and enamel between T2 and T3. In conclusion, erosion negatively affected the surface properties and appearance of the CAD/CAM restorative materials and human enamel. Repolishing contributed to restoring the compromised SMH of the eroded restorative materials and enamel to a certain extent. However, repolishing did not restore the color of the eroded restorative materials and enamel.