Abstract

The planetary boundary layer (BL) height and stratification are key parameters in determining the exchange of heat, momentum, moisture and trace gases between the surface and the free troposphere. Numerous different methods have been used to quantify the BL height and these methods have been applied to a wide variety of observational data sets obtained from different instruments and to numerical model output. We investigate the BL height at the Hyytiälä SMEAR II station in southern Finland diagnosed from radiosonde observations, a microwave radiometer (MWR) and ERA5 reanalysis. Four different algorithms are used to diagnose the BL height from the radiosondes. The diagnosed BL height is sensitive to the method used and the level of agreement, and the sign of systematic bias, between the 4 different methods depends on the surface-layer stability. For example, for very unstable situations, the median BL height diagnosed from the radiosondes varies from 600 m to 1500 m depending on which method is applied. Good agreement between the BL height in ERA5 and diagnosed from the radiosondes using Richardson number-based methods is found for almost all stability classes, suggesting that ERA5 has adequate vertical resolution near the surface to resolve the BL structure. However, ERA5 overestimates the BL height in very stable conditions highlighting the on-going challenge for numerical models to correctly resolve the stable BL. Furthermore, ERA5 BL height differs most from the radiosondes at 18 UTC suggesting ERA5 does not resolve the evening transition correctly. This study has also shown that BL height estimates from the MWR are reliable in unstable situations but often are inaccurate under stable conditions when, in comparison to ERA5 BL heights, they are much deeper. The errors in the MWR BL height estimates originate from the limitations of the manufacturers algorithm for stable conditions and also the mis-identification of the type of BL. A climatology of the annual and diurnal cycle of BL height and observed surface layer stability was created. The shallowest (353 m) monthly median BL height occurs in February and the deepest (576 m) in June. In winter there is no diurnal cycle in BL height, unstable BLs are rare yet so are very stable BLs. The shallowest BLs occur at night in spring and summer and very stable conditions are most common at night in the warm season. Finally, using ERA5 gridded data we determined that the BL height observed at Hyytiälä is representative of most land areas in southern and central Finland. However, the spatial variability of the BL height is largest during daytime in summer reducing the area over which BL height observations from Hyytiälä would be representative of.

Highlights

  • The boundary layer (BL) is the lowest part of the troposphere and is in direct contact with the Earth’s surface

  • While we focus on one specific station, it should be noted that the methods described here are applicable, in principle, to many stations worldwide, for example all European Aerosols, Clouds, and Trace gases Research InfraStructure (ACTRIS) stations and Atmospheric Radiation Measurement (ARM) program locations

  • Stable BLs are not characterised by inversions and Seibert et al (2000) note that for the stable BL "no universal relationship seems to exist between the profiles of temperature, humidity or wind and turbulence parameters." we describe the 210 methods applied to the radiosonde, microwave radiometer and reanalysis data sets to quantify the BL height

Read more

Summary

Introduction

The boundary layer (BL) is the lowest part of the troposphere and is in direct contact with the Earth’s surface. The boundary-layer height and stability are crucial variables to include in the analysis of surface-based aerosol and trace gas concentration observations as often measurements performed at ground-based stations are generalised to represent conditions throughout the BL and across larger horizontal scales The accuracy of such an assumptions depends on spatial and temporal variations in the BL height. The aim of the current study is to provide an in-depth, long-term analysis of boundary-layer height and stability at SMEAR II by combining a range of observations made over the 25-year history of the station from a wide range of different instruments 85 along with the most modern global reanalysis data set from ECMWF, ERA5.

SMEAR II
Radiosondes
Microwave Radiometer
Eddy Covariance and surface stability
ERA5 reanalysis
BL height from radiosonde soundings
BL height from ERA5
Case studies
BL height diagnosed from Microwave radiometer measurements
Systematic comparison of BL height diagnosed from different methods
Comparison of the 4 Radiosondes methods
Comparison of the radiosondes methods to ERA5
Microwave Radiometer and ERA5
Boundary-layer height and surface-layer stability climatology at Hyytiälä
Spatial variability of BL height in ERA5
Discussion and Conclusions
Findings
815 References
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call