Abstract
<strong class="journal-contentHeaderColor">Abstract.</strong> Non-rainfall water (NRW), defined here as dew, hoar frost, fog, rime, and water vapour adsorption, might be a relevant water source for ecosystems, especially during summer drought periods. These water inputs are often not considered in ecohydrological studies, because water amounts of NRW events are rather small and therefore difficult to measure. Here we present a novel micro-lysimeter (ML) system and its application which allows us to quantify very small water inputs from NRW during rain-free periods with an unprecedented high accuracy of <span class="inline-formula">±0.25</span>âg, which corresponds to <span class="inline-formula">±0.005</span>âmm water input. This is possible with an improved ML design paired with individual ML calibrations in combination with high-frequency measurements at 3.3âHz and an efficient low-pass filtering to reduce noise level. With a set of ancillary sensors, the ML system furthermore allows differentiation between different types of NRW inputs, i.e. dew, hoar frost, fog, rime, and the combinations among these, but also additional events when condensation on leaves is less probable, such as water vapour adsorption events. In addition, our ML system design allows one to minimize deviations from natural conditions in terms of canopy and soil temperatures, plant growth, and soil moisture. This is found to be a crucial aspect for obtaining realistic NRW measurements in short-statured grasslands. Soil temperatures were higher in the ML compared to the control, and thus further studies should focus on improving the thermal soil regime of ML. Our ML system has proven to be useful for high-accuracy, long-term measurements of NRW on short-statured vegetation-like grasslands. Measurements with the ML system at a field site in Switzerland showed that NRW input occurred frequently, with 127 events over 12 months with a total NRW input of 15.9âmm. Drainage-water flow of the ML was not measured, and therefore the NRW inputs might be conservative estimates. High average monthly NRW inputs were measured during summer months, suggesting a high ecohydrological relevance of NRW inputs for temperate grasslands.
Highlights
Non-rainfall water (NRW) inputs, defined here as dew, hoar frost, fog, rime, and water vapour adsorption, provide water to plants
NRW inputs occur during events with a finite time period, and for NRW input studies, the relative change in mass from the start to end of that time period is of interest
The residuals were in the range of ±0.25 g or ±0.005 mm equivalent water input, which represents the accuracy of the ML system (Riedl, 2021)
Summary
Non-rainfall water (NRW) inputs, defined here as dew, hoar frost, fog, rime, and water vapour adsorption, provide water to plants. These different inputs form under different environmental conditions: dew forms on plant surfaces when the temperature of the surface drops below the dew-point temperature of the adjacent air (Beysens, 2018; Monteith, 1957), whereas dew forming directly on soil surfaces is rarely observed (Agam and Berliner, 2004; Ninari and Berliner, 2002). Fog droplets form on condensation nuclei (activated aerosol particles) in the atmosphere when water vapour concentration reaches saturation, whereas rime is supercooled fog in contact with a surface (e.g. vegetation) at a temperature below 0 ◦C.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have