Removal of SO2from Flue Gas Using Basic Aluminum Sulfate Solution with the Byproduct Oxidation Inhibition by Ethylene Glycol

Abstract

This paper presents a novel wet flue gas desulfurization (FGD) technology based on a basic aluminum sulfate (BAS) desorption regeneration process, in which ethylene glycol (EG) was first employed to inhibit the byproduct oxidation. The operating parameter effect on SO2 absorption efficiency and oxidation efficiency of sulfite was thoroughly examined in a lab-scale bubbling column. The results indicated that both the amount of aluminum and basicity play important roles on the desulfurization time with above 90% absorption efficiency. The BAS-based desulfurization process was more suitable for a low temperature and low gas flow rate. High inlet SO2 concentrations may contribute to the mass-transfer rate of SO2, and the SO2 absorption efficiency remained above 90% when the pH value was over 3.10. With the addition of 1% (v/v) EG in BAS solution, the oxidation efficiency dropped dramatically from 86 to below 10% (in 120 min). On the basis of the two-film theory, a model of the SO2 absorption process was developed and the mass-transfer characteristics were analyzed. The calculation results indicated that the SO2 absorption process for this system was decided by a combination of both the gas- and liquid-phase diffusion controls.