Removal of α-Picoline, β-Picoline, and γ-Picoline from Synthetic Wastewater Using Low Cost Activated Carbons Derived from Coconut Shell Fibers

Abstract

In the present study the ability of activated carbons developed from coconut shell fibers to remove alpha-picoline, beta-picoline, and gamma-picoline from aqueous solution in the broad range of concentrations (1-100 mg/L) is investigated. The derived carbons are designated as FAC (activated carbon derived from coconut shell fibers without any treatment) and ATFAC (activated carbon derived from acid treated coconut shell fibers). Systematic equilibrium and kinetic adsorption studies at different pH, temperatures, particle size, and solid-to-liquid ratio were carried out to determine various parameters necessary to establish the fixed bed reactors. The Langmuir and Freundlich models were applied and the data are not fitted well by the Freundlich and Langmuir equations, but the Langmuir model has an edge over Freundlich model. The monolayer adsorption capacity (Q0) as calculated using Langmuir adsorption isotherm of the activated carbons viz., FAC and ATFAC is found to increase with an increase in temperature confirming the endothermic process. The ATFAC has a higher sorption capacity than FAC. Overall the adsorption of alpha-picoline, beta-picoline, and y-picoline on FAC and ATFAC follow the order FACalpha-picoline < ATFACalpha-picoline < FAC gamma-picoline < ATFACbeta-picoline < FACbeta picoline < ATFAC gamma-picoline. The adsorption of alpha-,beta-, and gamma-picoline followed the pseudosecond-order rate kinetics. On the basis of these studies, various parameters such as effective diffusion coefficients, activation energy, and entropy of activation were evaluated to establish the mechanisms. It was concluded that the adsorption occurred through particle diffusion at low temperatures viz., 10 degrees C and 25 degrees C (except alpha-picoline where it was film diffusion), while at 40 degrees C it occurred through film diffusion. Similarly at concentrations of 25 and 50 mg/L the adsorption was particle diffusion controlled (except for alpha-picoline where it was film diffusion), while at > 50 mg/L it was film diffusion controlled.