Removal of Manganese and Iron from Groundwater by using Chlorination and Rapid Sand Filtration: A Case Study

Abstract

The average groundwater extraction from Murunkan well field, Mannar, is around 3.4 MCM/year, and it was triggered by extensive development projects and resettlements that took place in the last decade. Manganese and Iron variations in Murunkan groundwater reported during some periods created various operational and aesthetic issues in the potable water supply. This study is focused on treating iron and manganese in groundwater using chlorination and Rapid Sand Filtration (RSF) techniques. Pebble layers, height of 205 mm with the particle sizes ranging from 2-25 mm, were filled at the bottom of RSF model filter. Filter media, height of 700 mm with 0.45 mm effective size (D10) and a uniformity coefficient (Cu) of 1.33, was placed above the pebble layers. The filter was operated continuously for 15 days, and influent and effluent water samples were collected from 15 trials. Filter backwashing was performed after every two trials to maintain a consistent filtration rate. Raw water pH values ranged from 6.74 – 7.48. Chlorine solution (1.08-1.26 ppm) was added at the inlet point, and a 2.88 m water column was maintained, allowing adequate mixing and oxidation time. The results revealed that average removals of iron and manganese as 60% and 73%, respectively, while maximum removals of 93% and 91% were observed for iron and manganese, respectively.