Removal of crystal violet from water by poly acrylonitrile-co-sodium methallyl sulfonate (AN69) and poly acrylic acid (PAA) synthetic membranes

Abstract

Abstract The current investigation is focused on the removal of crystal violet (CV) from water by adsorption process (bach method). To achieve this purpose, specific membranes were prepared from poly acrylonitrile-co-sodium methallyl sulfonate (AN69) and poly acrylic acid (PAA) blends. The adsorption of CV onto AN69/PAA membranes was studied under various conditions: membrane composition, pH, contact time, initial concentration and temperature. To understand the effect of membrane morphology on adsorption process, scanning electronic microscopy (SEM) was employed to determine the features of section and membrane’s surface. From isotherm results, it was found that: the maximum adsorption capacity Q m was 1250 mg g−1, the Langmuir separation factor R L was lying between 0.33 and 0.76, the Freundlich intensity was higher than Unit (n = 1.25) and the adsorption process follows preferentially the Langmuir model (correlation constant R 2 = 0.99). The mechanism of adsorption is perfectly fitted by pseudo second order. The obtained results tend to confirm that the removal of dye molecules is due to the establishment of strong electrostatic interactions between cationic dye molecules and anionic membrane groups. The high adsorption capacity (1250 mg g−1) for the small dye molecules may open wide opportunities to apply these membranes in the removal of various hazardous pollutants commonly present in water.