Removal, mechanistic and kinetic studies of Cr(VI), Cd(II), and Pb(II) cations using Fe3O4 functionalized Schiff base chelating ligands.

Abstract

The Schiff base chelating ligands; (E)-2-(3,3-dimethoxy-2-oxa-7,10-diaza-3-silaundec-10-en-11-yl)phenol (L1), (E)-N-(2-((pyridine-2ylmethylene)amino)ethyl)-3-(trimethoxysilyl)propan-1-amine (L2) and (E)-N-(2-((thiophen-2-ylmethylene)amino)ethyl)-3-(trimethoxysilyl)propan-1-amine (L3) were immobilized on Fe3O4 magnetic nanoparticles (MNPs) and utilized in the extraction of Cr(VI), Cd(II) and Pb(II) metal cations from aqueous solutions. The compounds synthesized, denoted as L1@ Fe3O4, L2@Fe3O4, and L3@Fe3O4, were characterized using FT-IR spectroscopy, TEM-SEM, VSM, and BET/BHJ techniques for analysis of functional groups, surface morphology, magnetic properties, and degree of porosity of the adsorbents, respectively. BET/BHJ technique confirmed the mesoporous nature of the compounds as their pore diameters ranged between 15 and 17nm. The initial optimization conditions of pH, adsorbent dosage, initial metal concentration, and contact time on adsorption were studied using L1@ Fe3O4. The optimum efficiencies recorded were 68% and 46% for Cr(VI) and Cd(II), respectively, obtained at pH 3, and a metal concentration of 20ppm while an efficiency of 99% was recorded for Pb(II) cations at pH 7 and a metal concentration of 100ppm. Compounds L2@Fe3O4 and L3@ Fe3O4 were also used in the extraction of metal cations from aqueous solution and gave efficiencies of 22%, 56%, and 78% for L2@ Fe3O4 and 19%, 90%, and 59% using L3@ Fe3O4 for Cr(VI), Cd(II), and Pb(II), respectively. The maximum adsorption capacities of L1@ Fe3O4 for Cr(VI), Cd(II), and Pb(II) cations were obtained from the Langmuir isotherm as 32.84, 41.77, and 450.45mg/g, respectively. The experimental data was analyzed using pseudo-first-order, pseudo-second-order, intraparticle diffusion, and Elovich kinetic models. Both linear and non-linear forms of kinetic isotherms; Langmuir, Freundlich, Redlich-Peterson, and Temkin were utilized to investigate the nature of adsorption on L1@Fe3O4. The mechanistic studies deduced that the Langmuir isotherm and pseudo-second-order kinetic model better described the adsorption process both yielding high correlation coefficient values (R2 > 0.98).