Abstract
A mechanically amplified Fabry-Pérot optical accelerometer is reported in which photothermal actuation is used to calibrate the in-phase and quadrature (I&Q) readout. The Fabry-Pérot interferometer (FPI) is formed between a gold-coated silicon mirror, situated in the middle of a V-beam amplifier, and the end surface of a cleaved optical fiber. On the opposite side of the silicon mirror, a further cleaved optical fiber transmits near-infrared laser light (λ = 785 nm), which is absorbed by the uncoated silicon causing heating. The thermal expansion of the V-beam is translated into an amplified change in cavity length of the FPI, large enough for the 2π-phase variation necessary for I&Q calibration. A simple 1D thermal analysis of the structure has been developed to predict the relationship between laser power and change in cavity length. A device having a V-beam of length 1.8 mm, width 20 μm, and angle 2 ° was found to undergo a cavity length change of 785 nm at 30 mW input power. The device response was approximately linear for input accelerations from 0.01 to 15 g. The noise was measured to be ~ 60 μg/√Hz from 100 Hz to 3.0 kHz, whereas the limit of detection was 47.7 mg from dc to 3.0 kHz.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
