Abstract
Hydrogen chloride and sulphur dioxide are gaseous by-products of chloridization processes that employ thionyl chloride. Absorption would be a feasible method to clean the rich gas stream. Two serial connectable absorption columns were equipped with the latest generation of packings to effect product recovery. Therefore, several tests concerning the baffle properties had to be performed. In the first experimental section, the hydraulic parameters pressure drop and hold-up were investigated. The hold up value range of the new baffles Raschig Super Ring (RSR) and Raschig Super Pak (RSP) was clearly below that of the former installed packing, Raschig Ring (RR). However, due to the low maximal flow rate, the range of stagnation and flooding could not be measured. The maximal measured pressure drop value was, for RR, only 0.3 mbar/m, which is very low compared to the measurement error. Batch experiments, where the waste gases were produced by reaction of thionyl chloride in water, showed that for the steady state determination of the separation steps it is advisable to use just one column in simplex mode with a defined gas supply by a gas cylinder. The HTU determination for RSR and a HCl/H2O system delivered a value of HTUHCl,OG = 0.14 ± 0.01 m with a variation coefficient of 24.2%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
