Reliable determination of polymeric carbon nitride wettability: A standardized sessile drop method for pressed-tablet samples

Abstract

The wettability of polymeric carbon nitride (PCN) is an important surface chemical factor affecting its catalytic and separation performance. However, due to the amphipathic characteristics of hydrophilic/lipophilic and porous powder properties, the contact angle (CA) of PCN measured by the common sessile drop method will be interfered by the substrate, resulting in randomness of the results. Herein, the pristine PCNs obtained by thermal polycondensation of different precursors in air or nitrogen atmosphere were used as the wettability research object. The CA of the PCNs was measured by a modified sessile drop method after the traditional powders were replaced by pressed-tablet samples. The influence of sample mass and applied pressure on specific surface area, pore volume, surface morphology and CA of the pressed-tablet samples was investigated carefully, and the optimal experimental conditions were determined. When the sample mass was 0.15 g and the applied pressure was 10 MPa, the measured water CA of PCNs was between 27 ∼ 34°, and the diiodomethane CA is between 24 ∼ 29°. The measurement results showed considerable stability and reproducibility. This improved CA measurement method provides a simple and standardized way to accurately explore the surface chemistry of PCN, and has the potential to be applied to other hydrophilic and/or oleophilic porous powder materials.