Abstract

AbstractA study was undertaken to select a suitable coating for a high-pin-count flexible edge connector (Flex) that interconnected a multichip thin-film silicon carrier to a printed circuit board. The Flex with cantilevered inner leads were joined to the contact pads at the perimeter of the carrier. 15 polymeric coatings were evaluated by subjecting coated Flexes to tests consisting of inner lead bending, temperature/humidity/bias (85°C/80%/15 V/350 hours), corrosion, line peel, and/or pressure cooker (126°C/20 psig/120 hours). Inner lead bending measurements were performed to assess the potential of lead shorting at the inner lead bonding sites during thermal cycling. From this study, a low-stress silicone evolved as the best candidate. The results leading to this conclusion will be shown and discussed.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.