Abstract
Anisotropic conductive film (ACF) is commonly used as underfill for flip chip assembly. The present study focuses on elastic recovery and stress distribution along the interfaces of particle-pads and underfill-pads associated with heat or a mechanical loading. In the same manner as the experimental process for ACF assemblies, ACF interconnection is simulated using FEM. Firstly, the properties of the nickel were determined by fitting FEM to the experimental results. After that, the nickel properties are used for ACF interconnection analysis. We found that delamination may also occur at a three-joint interface of a particle, a pad and an underfill at the lowest temperature during a heat cycle.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
