Abstract
Muscular load on the back and hip muscles was quantified and compared using a muscular strength utilization ratio (MUR). The MUR was obtained by dividing the total moment about the bilateral joint axis by the counteracting maximum muscular strength at the same joint angle. 72 different postures during simulated packing work were studied, with different combinations of box size, angle, edge height and weight. The MUR was calculated for a large, an average sized and a small man depending on whether they were all either strong, of average strength, or weak, thus giving nine MUR values for each posture. For a weak man, the MUR exceeded 100% in many postures. The largest box at a zero- or 30-degree angle to the horizontal with its upper edge 20 cm below elbow height gave the highest MUR, while the smallest box angled at 90 degrees with the upper edge 10 cm above elbow height gave the lowest. The presented concept of relating joint load to strength is proposed for use in preventive ergonomic counselling and in vocational rehabilitation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
