Abstract
The effect of microstructures on the high-cycle fatigue (HCF) properties of Ti-6242S (Ti-6Al-2Sn-4Zr-2Mo-0.1Si) was investigated. Five different microstructural conditions were generated through combinations of hot-deformation and heat treatments, and each was fatigue-tested using smooth round bar specimens at an R ratio of 0.1. The HCF behavior was found to be highly dependent on microstructures. The bimodal microstructure showed the highest HCF strength in the whole cycle range with 750 MPa at 1.0E+07 cycles. The fatigue ratio S of the HCF strength at 1.0E+07 cycles to tensile strength showed its highest value of 0.65 for the acicular α-microstructure whereas it showed its lowest value of 0.49 for the full lamellar microstructure. The flat facets were observed at the fatigue crack initiation sites irrespective of the microstructures, and were always located in the subsurface regions. Concurrent observation of the fatigue initiation facet and the underlying microstructure was made using the precision sectioning method. Based on these experimental results, the main factor contributing to the improvement of HCF strength was analyzed, along with the correlation between facet morphologies and fatigue life-controlling microstructural units, the fatigue initiation mechanisms and the dependence of HCF strength on the facet size.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
