Year-end Sale % OFF 
Abstract
AbstractLarge DC motors are used in various industrial applications. These motors repeatedly generate arcs between the brush and commutator, because the load change is intense and the current value is also large. In particular, for the case in which the current is concentrated on a part of the brush, brush burnout may occur as a result of overcurrent. Therefore, excellent brushes to withstand arc generation and with good electrical properties are required. In the present paper, we discuss the relation between contact voltage drop and frictional wear for electrical sliding contacts when high currents flow to the brush. Specifically, we investigate the means by which to prevent brush burnout when high‐current flows to the brush. Copyright © 2010 Institute of Electrical Engineers of Japan. Published by John Wiley & Sons, Inc.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEJ Transactions on Electrical and Electronic Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
