Abstract

Water exhibits a maximum in density at normal pressure at 4 degrees above its melting point. The reproduction of this maximum is a stringent test for potential models used commonly in simulations of water. The relation between the melting temperature and the temperature of maximum density for these potential models is unknown mainly due to our ignorance about the melting temperature of these models. Recently we have determined the melting temperature of ice I(h) for several commonly used models of water (SPC, SPC/E, TIP3P, TIP4P, TIP4P/Ew, and TIP5P). In this work we locate the temperature of maximum density for these models. In this way the relative location of the temperature of maximum density with respect to the melting temperature is established. For SPC, SPC/E, TIP3P, TIP4P, and TIP4P/Ew the maximum in density occurs at about 21-37 K above the melting temperature. In all these models the negative charge is located either on the oxygen itself or on a point along the H-O-H bisector. For the TIP5P and TIP5P-E models the maximum in density occurs at about 11 K above the melting temperature. The location of the negative charge appears as a geometrical crucial factor to the relative position of the temperature of maximum density with respect to the melting temperature.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call