RELAP5 Analyses of ROSA/LSTF Experiments on AM Measures during PWR Vessel Bottom Small-Break LOCAs with Gas Inflow

Abstract

RELAP5 code posttest analyses were performed on ROSA/LSTF experiments that simulated PWR 0.2% vessel bottom small-break loss-of-coolant accidents with different accident management (AM) measures under assumptions of noncondensable gas inflow and total failure of high-pressure injection system. Depressurization of and auxiliary feedwater (AFW) injection into the secondary-side of both steam generators (SGs) as the AM measures were taken 10 min after a safety injection signal. The primary depressurization rate of 55 K/h caused rather slow primary depressurization being obstructed by the gas accumulation in the SG U-tubes after the completion of accumulator coolant injection. Core temperature excursion thus took place by core boil-off before the actuation of low-pressure injection (LPI) system. The fast primary depressurization by fully opening the relief valves in both SGs with continuous AFW injection led to long-term core cooling by the LPI actuation even under the gas accumulation in the SG U-tubes. The code indicated remaining problems in the predictions of break flow rate during two-phase flow discharge period and primary pressure after the gas inflow. Influences of the primary depressurization rate with continuous AFW injection onto the long-term core cooling were clarified by the sensitivity analyses.