Regulating Movement Frequency and Speed: Implications for Lumbar Spine Load Management Strategies Demonstrated Using an In Vitro Porcine Model.

Abstract

The relationship between internal loading dose and low-back injury risk during lifting is well known. However, the implications of movement parameters that influence joint loading rates-movement frequency and speed-on time-dependent spine loading responses remain less documented. This study quantified the effect of loading rate and frequency on the tolerated cumulative loading dose and its relation to joint lifespan. Thirty-two porcine spinal units were exposed to biofidelic compression loading paradigms that differed by joint compression rate (4.2 and 8.3kN/s) and frequency (30 and 60 cycles per minute). Cyclic compression testing was applied until failure was detected or 10,800 continuous cycles were tolerated. Instantaneous weighting factors were calculated to evaluate the cumulative load and Kaplan-Meier survival probability functions were examined following nonlinear dose normalization of the cyclic lifespan. Significant reductions in cumulative compression were tolerated when spinal units were compressed at 8.3kN/s (P < .001, 67%) and when loaded at 30cycles per minute (P = .008, 45%). There was a positive moderate relationship between cumulative load tolerance and normalized cyclic lifespan (R2 = .52), which was supported by joint survivorship functions. The frequency and speed of movement execution should be evaluated in parallel to loading dose for the management of low-back training exposures.