Abstract
Desorption of ethylene/ethane and carbon dioxide/methane mixtures was performed by microwave heating and conductive heating on Na-ETS-10. Gas recovery, Na-ETS-10 regeneration efficiency and swing capacity were compared between the two methods. Na-ETS-10 regeneration occurred within 8min for microwave heating and 22min for conductive heating. For microwave heating the energy consumption was 0.7kJ/g Na-ETS-10 and the gas recovery was 94% for C2H4/C2H6 and 70% for CO2/CH4. Conductive heating had an energy consumption of 7.7–7.9kJ/g Na-ETS-10 and resulted in 71% gas recovery for C2H4/C2H6 and 57% for CO2/CH4. The adsorption capacity of Na-ETS-10 did not change over five adsorption–regeneration cycles for both heating techniques. Microwave desorption provided a faster heating rate and desorption rate, higher desorption and gas recovery and lower energy consumption compared to conductive heating. Hence, microwave heating can be used as a more efficient and energy saving regeneration technique for Na-ETS-10 for adsorptive separation of binary mixtures such as C2H4/C2H6 and CO2/CH4.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
