Regenerated cellulose membrane prepared with ionic liquid 1‐butyl‐3‐methylimidazolium chloride as solvent using wheat straw

Abstract

AbstractBACKGROUND: Currently, cellulose membranes are prepared by cellulose acetate hydrolysis or chemical derivatization dissolution and regeneration using cotton pulp or wood pulp. In this study, the concept ‘lignocelluloses biorefinery’ was used, and good quality long fiber was fractionated from wheat straw using clean technologies. The objective of this study is to develop wheat straw cellulose to prepare regenerated cellulose membrane with ionic liquid 1‐butyl‐3‐methylimidazolium chloride ([BMIM]Cl) as solvent.RESULTS: Wheat straw cellulose (WSC) fractionated from wheat straw contained 93.6% α‐cellulose and the degree of polymerization (DP) was 580. WSC was dissolved directly without derivatization in [BMIM]Cl. With increase in dissolving temperature, the DP of the regenerated cellulose dropped, which resulted in a decrease in the intensity of regenerated cellulose membrane. After regeneration in [BMIM]Cl, the WSC transformed from cellulose I to cellulose II, and the crystallinity of the regenerated cellulose was lower than the original cellulose. The regenerated WSC membrane had good mechanical performance and permeability, the tensile strength and breaking elongation were 170 MPa and 6.4%, respectively, the pure water flux was 238.9 L m−2 h−1 at 0.3 MPa pressure, and the rejection of BSA was stabilized at about 97%.CONCLUSION: Wheat straw cellulose fractionated from wheat straw satisfied the requirement to prepare regenerated cellulose membrane using ionic liquid [BMIM]Cl as solvent. Copyright © 2012 Society of Chemical Industry