Abstract
Investigation deals with application of new kind of soldering equipment and development of reflow soldering processes for electronic devices using this equipment. It is based on low inert heaters for the middle IR spectral region. Due to low inertia of the heaters temperature changes in the soldering camera may be controlled precisely and the soldering cycle may be realized at the same place without conveyor belt. The printed circuit board (PCB) of the device is relatively big with different electronic components density in different zones of its surface. Used electronic components demand precise soldering cycle parameters realization. Temperature monitoring of the whole PCB's surface necessary for technological operation development practically is impossible by conventional measurement techniques. Good results are obtained using IR thermography with IR camera for the middle IR spectral region. Results of this investigation allow adjusting proper regime of operation of the soldering equipment and successful realization of soldering processes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
