Abstract
In the current work, the effect of partial substitution of Er-sites for the Y-sites in the bulk YBa2Cu3O7−y (YBCO) crystal system on the fundamental superconducting, electrical, crystallinity and structural morphology features is examined together with the reasons by means of powder X-ray diffraction (XRD), temperature-dependent electrical resistivity (ρ-T), scanning electron microscopy (SEM), electron dispersive X-ray (EDX) investigations and deduced calculation parameters. All the experimental test results show that the erbium impurities are successfully substituted by the yttrium sites in the bulk Y-123 crystal system, confirmed by sensitively the EDX and ρ-T measurement results. Moreover, it is found that all the fundamental characteristic quantities improve with the increment in the Er/Y partial substitution level up to the value of x = 0.03 beyond which the features tend to degrade dramatically. In this respect, the bulk Y1−xErxBa2Cu3O7−y ceramic compound prepared within the molar ratio of x = 0.03 crystallizes in the orthorhombic space group P4/mmm with a little distortion due to the refinement in the crystallinity quality, crystallite growth, oxygen ordering degree, scattering mechanism, intra and inter-grain boundary couplings, grain alignment distributions and orientations. The XRD results show that the optimum erbium content enables to develop seriously the fundamental crystallographic features (lattice strain, lattice cell constants, crystallite size distribution, dislocation density ratio, oxygen concentrations in the unit cells) of Y-123 crystal structure. However, the excess Er/Y substitution leads to enhance considerably the systematic structural problems and inhomogeneous distribution of strains (formed by the structural defects) in the YBCO crystal structure. Thus, the phase transition from orthorhombic to tetragonal (structural O–T transition) crystal structure is observed. In fact, the XRD result displays that the trivalent Er3+ particles may partially be replaced by the divalent Cu2+ host atoms in the bulk Y-123 crystal structure after the critic substitution level of x = 0.03. The optimum Er concentration causes to form more thermodynamically activated super-electrons in the homogeneous superconducting cluster percentages in the paths due to the induced polaronic effect, and accordingly the intrinsic overdoped nature of Y-123 ceramic system transits into optimally doped state. Similarly, the erbium ions enable to increase the mobile hole carrier concentration and homogeneities in the oxidation state of superconducting grains. Namely, the amplitude of pair wave function (Ψ = Ψ0e-iφ) is strength enough to form bipolarons in the polarizable lattices and localize of densities of electronic states (DOS) at Fermi level. SEM investigations picture that the surface morphology view and crystallinity quality develop remarkably with the increment in the erbium content up to the critical dopant level of x = 0.03 where the sample exhibits the best grain alignment orientations, densest and smoothest surface morphology with the combination of lowest porous and largest particle distributions well linked each other. All in all, this comprehensive work based on the analysis of Er/Y partial replacement mechanism along the YBa2Cu3O7−y ceramic matrix may open up a newly/novel and feasible area for the advanced engineering, heavy-industrial technology and large-scale applications of type-II superconducting materials.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.