Abstract
For increasing the load carrying capacity of geared power transmissions several tooth designs alternative to the standard involute have been proposed. The use of non-involute teeth has a number of disadvantages and for this reason asymmetric involute-type teeth have been studied as a promising alternative. In this paper the idea of one-sided involute asymmetric spur gear teeth is introduced to increase load carrying capacity and combine the good meshing properties of the driving involute and the increased strength of non-involute curves. These novel teeth are intended for constant direction of rotation although they can be used in a limited way for reverse rotation. Both flanks are fully generated by a hob, the design of which is also investigated. The increase in load carrying capacity can reach up to 28% compared to the standard 20° involute teeth.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.