Reduction in burst release of PLGA microparticles by incorporation into cubic phase-forming systems

Abstract

A high initial burst release of an phosphorothioate oligonucleotide drug from poly(lactide-co-glycolide) (PLGA) microparticles prepared by the w/o/w solvent extraction/evaporation was reduced by incorporating the microparticles into the following glycerol monooleate (GMO) formulations: 1) pure molten GMO, 2) preformed cubic phase (GMO + water) or 3) low viscosity in situ cubic phase-forming formulations (GMO + water + cosolvent). The in situ cubic phase-forming formulations had a low viscosity in contrast to the first two formulations resulting in good dispersability of the microparticles and good syringability/injectability. Upon contact with an aqueous phase, a highly viscous cubic phase formed immediately entrapping the microparticles. A low initial burst and a continuous extended release over several weeks was obtained with all investigated formulations. The drug release profile could be well controlled by the cosolvent composition with the in situ systems.