Abstract
Transition metal oxides like Fe2O3, Co3O4, NiO, and CuO have mainly been used in the chemical-looping combustion (CLC) reaction as oxygen carrier particles because of their outstanding performances due to high reduction potential. However, monometal oxides have a serious problem of rapid deactivation due to agglomeration between each particle after several redox cycles. In order to solve this problem, bimetal oxides based on Mn, which undergoes no deactivation, were synthesized. Mn-based bimetal oxygen carrier particles Fea-Mnb-Ox, Coa-Mnb-Ox, Nia-Mnb-Ox, and Cua-Mnb-Ox were synthesized by using a sol–gel method. The range of a and b in the particle label obtained in this study is 0.5–2.5, depending on the metal content added. The chemical and physical properties of the prepared particles were examined using X-ray diffraction (XRD), scanning electron microscopy (SEM), CH4-/CO-temperature programmed desorption, and thermogravimetric analysis (TGA). The XRD results showed that the prepared particles comprised two- or three-phase mixed metal oxides. The Fe2.0-Mn1.0-Ox particle was in the phases of Fe2Mn1O4 and Fe20.16Mn11.84O48, respectively, and the Co2.0-Mn1.0-Ox particle had the phase of Co2Mn1O4. In addition, Ni2.0-Mn1.0-Ox particle has NiO and Ni1Mn2O4 phases, and Cu2.0-Mn1.0-Ox particle exist in the phases of CuO, Cu2O and Cu1Mn1O2, respectively. The distributions of added elements on the particles were observed from the SEM mapping results. The oxygen carrier capacities of the particles were tested by isothermal H2/air and CH4/air redox cycle experiments using TGA at 850°C. The improved results obtained in this study revealed that the Cu2.0-Mn1.0-Ox particle was an enhanced bimetal oxide oxygen carrier for CLC under CH4/air conditions. In particular, among the synthesized particles, the Cu2.0-Mn1.0-Ox particle stably showed 16.7wt% oxygen transfer capacity over 10 redox cycle under CH4/air at 850°C.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
