Reducing Temperature of Fused Deposition Modelling 3D Printing for Linalool Fast Dissolving Oral Films by Increasing Printer Nozzle Diameter

Abstract

Oral thrush and throat infections can occur in a wide range of patients. Treatments are available; however, resistance to drugs is a major problem for treating oral and throat infections. Three-dimensional printing (3DP) of fast dissolving oral films (FDFs) of linalool oil may provide an alternative solution. Linalool oil FDFs were printed by fused deposition modelling across 1–18 % w/w linalool content range with nozzle diameters of 0.4 or 1 mm at the temperature range of 150 °C-185 °C. The FDFs were evaluated for physicochemical and mechanical properties. Increasing the printer nozzle diameter to 1 mm allowed reducing the printing temperature from 185 °C to 150 °C; consequently, more linalool was quantified in the films with improved content uniformity. The higher linalool content in the films increased the film disintegration time and mechanical strength. FDFs containing 10% w/w linalool showed clear antifungal activity against Candida albicans. Raman spectroscopy suggested linalool separation from excipients at higher temperature printing. Viscoelastic measurements indicated that to achieve printing; the elastic modulus of molten filament needed to be higher than the loss modulus at low angular frequencies. In conclusion, increasing the printing nozzle diameter may avoid loss of the active ingredient by reducing the temperature of the 3DP process.