Reducing Oxidation during Direct Metal Deposition Process: Effects on Ti6Al4V Microstructure and Mechanical Properties

Abstract

The production of materials with a high affinity for oxidation using the direct metal deposition (DMD) process requires an extended process examination that goes beyond the usual, purely energetic consideration, with the aim of providing sufficient energy to melt the substrate and the powder material supplied. This is because the DMD process does not allow any conclusions to be drawn as to whether it and its respective selected parameters result in an oxidation critical process. To assess this, a superposition of the temperature field with the existing spatial oxygen concentration is required. This work uses this approach to develop an oxidation model that reduces oxidation during the DMD process. In addition to the numerical model, an analytical model is derived, with which the temperature of a material element can be calculated analytically and the resulting boundary oxygen concentration calculated using Fick’s 2nd law. The model also takes into account two-stage oxidation kinetics for Ti alloys. The effect of too high a travel speed (with the same specific energy of the other experiments) is shown visually in the numerical calculation of the temperature field. However, if the process model is taken into account, the components do fulfil the specified requirements. Finally, the effect of oxidation on the microstructure, microhardness, ultimate strength, yield strength and elongation at failure of Ti6Al4V structures produced using DMD is also investigated, and further supports our conclusions regarding the effectiveness of the proposed model.