Abstract
Takagi Sari Multi Utama is an automotive company engaged in injection molding, producing automotive products such as motor vehicle parts, car interiors, and exteriors. One of the main influences of the prolonged dandory process is the distance between the mold parking area and the machine, resulting in a total process time of 48.95 minutes, while the company's standard is set at 40 minutes. Minimizing the time can cause the dandory process of mold change using the Single Minute Exchange of Dies (SMED) method by converting the time of internal setup activities into external setup activities. The improvement results using the Single Minute Exchange of Dies (SMED) method reduced the time to 27.67 minutes or equivalent to 1,660.13 seconds. The reduction in dandory mold change process time on the 1800T injection molding machine is 21.29 minutes or equivalent to 1,277.16 seconds, with a percentage decrease of 44%
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Advanced Technology and Social Sciences
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
