Abstract
This study focused on bug-holes on sidewalls of tunnel lining concrete. The bug-holes of lining concrete may negatively affect aesthetics and durability of NATM (New Austrian Tunneling Method) tunnels. Most bug-holes appeared on concrete surface are generated from entrapped air during consolidating concrete. In particular, the sidewall of tunnel lining is constructed with negative angles, so bug-holes are often observed on the sidewall. Seven concrete specimens were prepared to simulate conventional tunnel lining. In the experimental investigation, breathable-waterproof material sheets and permeable sheets were used. The primary experimental parameters are (a) covering-sheet materials and (b) form surfaces such as ceramic-coated steel with grooves. The study examined bug-hole distributions in the concrete specimens using the various sheets. The bug-hole distributions were quantified by using an image analysis developed in this study. The test results show that quantity of bug-holes of concrete using the sheets is lower than the quantity of concrete without sheets. It was noteworthy that the bug-holes were hardly observed in the test using the form covered with the permeable sheets.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Proceedings of International Structural Engineering and Construction
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.