Reduced-Reflection Multilayer PCB Microstrip with Discontinuity Characterization

Abstract

In the era of technology and communication, printed circuit boards (PCBs) can be found in a myriad of devices—from ordinary household items, to state of the art custom metrology equipment. Different types of component for wireless communications are available and come in various packages, supplied by multiple manufacturers. The signal landpads for some high-frequency connectors and components, encapsulated in larger packages, are usually wider than the controlled impedance trace, thereby introducing unwanted impedance mismatch and resulting in signal reflections. The component land pad and microstrip width a discrepancy issue can be found in both complex high-density industrial devices and system-level academic research papers. This paper addresses the topic of compensating discontinuities, introduced by signal pads, which are wider than the target impedance microstrip, characterizes the difference between the compensated and uncompensated microstrip with discontinuity, and proposes a generalized guideline on compensating for the introduced impedance change in multilayer PCBs. The compensation method is based upon carefully designing the stackup of the PCB allowing for a reference plane cutout under the discontinuity to even out the impedance mismatch. A 6-layer PCB with IT180A dielectric material containing three structures has been manufactured and characterized using an Agilent E8363B vector network analyzer (VNA). A 4–12 dB improvement in S11 response in the whole frequency range up to 10 GHz, compared to that when no compensation has been applied, was observed.