Reduced native right ventricular T1 in Anderson-Fabry disease as compared to patients with pulmonary hypertension

Abstract

Methods In images from 20 subjects with FD and 7 subjects with pulmonary hypertension (PH), the inferior RV wall was assessed for the appearance of hypertrophy, to identify subjects with sufficient wall thickness for T1 analysis. Images were acquired on 1.5T Siemens systems (Sonata and Avanto) using the SASHA T1 mapping method[3] for all studies: 70° flip angle, 1.31 ms echo time, 2.62 ms repetition time, 9 images with 85-995 ms saturation recovery times plus a non-saturated image, 8 mm slice thickness, 360 × 270 FOV, 192 × 108 acquisition matrix before interpolation, and 75% phase resolution. Either rate 2 parallel imaging (GRAPPA) or 6/8 partial Fourier was used for image acceleration. Regions of interest were drawn on the septum and inferior RV by two observers, avoiding the septal insertion point, fat and blood pool. Analysis was repeated 10 times per subject to evaluate T1 variability with ROI placement. Late gadolinium enhancement (LGE) and diastolic regional wall thickness (WT), measured on bSSFP cine images, were assessed at a comparable slice location. Results Analysis was performed in 5 patients with FD and 4 patients with PH (WT(LV-FD) = 11.7 mm, WT(RV-FD) = 5.7 mm, WT(LV-PH) = 10.8 mm, WT(RV-PH) = 7.5 mm), as the remaining cases had inadequate hypertrophy and spatial resolution to proceed with analysis. Sample SASHA images are shown in Figure 1. Figure 2 shows T1 values for all subjects, demonstrating lower myocardial T1 in both the LV and RV for all FD subjects (p = 0.0143 for either ventricles). Interobserver agreement (coefficient of variation) was 4.0% and 2.41% for the RV and septum, respectively. No FD subjects were positive for LGE in the inferior RV or septum; however one was positive at the RV insertion point. No PH subjects were positive for LGE in the inferior wall; however 2 showed mid-wall septal enhancement at locations within ROIs and all were positive at the RV insertion site. However, as indicated in Figure 2, septal T1 values are similar in those positive (1340.7 & 1249.7 ms) and or negative (1459.4 & 1215.0 ms) for LGE.