Abstract
We have fabricated the NO2 gas sensors by using reduced graphene oxide (RGO) functionalized with copper (Cu) nanoparticles, revealing that the sensitivity was significantly enhanced by the Cu functionalization. Transmission electron microscopy indicated that the nanoparticles with a cubic Cu phase were attached on the surface of RGO. Raman spectra revealed that the structural disorder of RGO was increased by the Cu-functionalization. We performed the NO2 gas sensing test, revealing that the sensor response of RGOs was increased by 326% by means of the Cu-functionalization. We have discussed the associated mechanisms. In addition, we have ascribed the functionalization-induced changes of response and recovery times to the increase of low-energy binding sites.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
