Redesign of Split-Hopkinson Tensile bar to eliminate spurious wave and verification of strain signal using FEM

Abstract

To get the reliable dynamic material properties, the optimization of measuring apparatus such as SHTB (Split-Hopkinson Tensile Bar) is essential. SHTB apparatus is a machine that can acquire the material properties of a specimen for given high-speed situation in [Formula: see text] strain rate region. In this study, a new model improved the waveform is proposed by redesigning and optimizing the initial SHTB equipment. Complete reflected pulse was not obtained, and a spurious wave was measured in original model. To obtain reliable material properties, the spurious wave must be removed or avoided. Factors affecting spurious wave were determined as length of striker bar, length of incident bar, and diameter of striker bar & flange, and verified using LS-DYNA, one of the FEM (Finite-Element Method) software. The modified model was redesigned and manufactured based on FEM results. In FEM results, the incident and reflected pulse were completely improved. Also, overlapping with spurious wave was avoided in redesigned experiment results. Redesigned model was confirmed the residual wave after the incident pulse by a pneumatic launcher and various mechanical components. However, the residual wave didn’t affect the reflected pulse and the waveform was improved than the original model.