Abstract
The production of waste bottom ash (BA) from coal power plants in the west coast of South Korea has been a serious environmental problem to resolve. In this investigation, waste BA was recycled to prepare BA/polypropylene and BA/polyethylene composites, and their mechanical properties were compared. The hazardous metal content in the waste BA was minimal, and the waste BA was not contaminated by sea water. The surface of the BA was coated with one of three cationic surfactants, cetylpyridinium chloride, benzethonium chloride, or benzalkonium chloride, to improve the interface compatibility between the polymer matrices and BA surface. The mechanical properties of the BA composites decreased as the BA content increased and were dependent on the content of BA rather than on particle size. Coating surfactants onto BA significantly improved the mechanical properties, especially the compressive strength, of the BA composites. Finally, the BA composites were successfully applied in the fabrication of a car parking safety product that satisfied the required safety standards.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.