Recycling and remanufacturing of 3D printed continuous carbon fiber reinforced PLA composites

Abstract

A cleaner production pattern for high-performance continuous carbon fiber reinforced thermoplastic composites (CFRTPCs) has been proposed on the base of recycling and remanufacturing of 3D printed continuous carbon fiber reinforced (CFR) PLA composites. Continuous carbon fiber and PLA matrix was recycled in the form of PLA impregnated carbon fiber filament from 3D printed composite components and reused as the raw material for further 3D printing process. The original printing trajectory is reversely applied, allowing for a 100% recycling of the continuous fiber without any effect on the mechanical properties. Tensile performance of recycled carbon fiber filaments was evaluated, which was higher than that of originally printed composites. Remanufactured CFRTPCs specimens also exhibited a 25% higher bending strength than that of original ones, which experimentally demonstrated the first non-downgrade recycling process for CFRTPCs. A material recovery rate of 100% for continuous carbon fiber and 73% for PLA matrix were achieved for a better environmental impact. Energy consumption of 67.7 and 66 MJ/kg respectively for recycling and remanufacturing processes was detected and compared with conventional methods. The proposed cleaner production pattern offered a potential strategy for the low-cost industrial application of fully recyclable composites.