Recrystallization behavior in a low-density high-Mn high-Al austenitic steel undergone thin strip casting process

Abstract

The recrystallization behavior of a high-Mn high-Al lightweight steel (Fe-28.4Mn-8.3Al-1.27 C (wt%)) with 50% cold rolling deformation is investigated at the annealing temperature of 800 °C, 900 °C and 1000 °C. The detailed microstructure evolution is characterized by optical microscopy (OM), scanning electron microscopy (SEM), electron backscatter diffraction (EBSD), X-ray diffraction (XRD), electron probe micro-analyzer (EPMA) and transmission electron microscopy (TEM). The partial recrystallized bimodal austenite grains and κ-phase (Fe, Mn)3AlC form at 800 °C, while fully recrystallized austenite grains without κ-phase appear at 900 °C and 1000 °C. With the increase in annealing temperature, the increased frequency of annealing twin boundaries reduces the average austenitic grain size and the dispersion of the austenite grain size effectively. The effect of austenite grain size on the tensile properties is discussed. The strain hardening behavior is also investigated by Hollomon analysis and C-J analysis, and the later one is better to explain the strain hardening behavior in different four stages. The recrystallization behavior significantly improves the tensile toughness from 59 MJ/m3 to 436 MJ/m3 at the expense of tensile strength decrease from 1460 MPa to 890 MPa, due to the homogenous fine austenite grains and high frequency of high misorientation angle. The steel with fully recrystallized austenite grains of 10.0 µm annealed at 900 °C exhibits the optimum mechanical properties with excellent tensile strength of 965 MPa, ductility of 48.3%, and good toughness of 400 MJ/m3.