Abstract
Abstract With the increasing use of 3D printing technology, a closely related problem is that of spreading. This problem is the presence of the polymer waste created by faulty prints, and support material used during printing. To create filament from this waste, it must first be chopped into fine pieces. In this project, an original polymer grinder was designed and built, adopting the innovations of Industry 4.0. Remote control and supervision were achieved using a Raspberry Pi I. type B and an Arduino Nano. The finished project can be seen in the faculty of engineering at the University of Debrecen.
Full Text 
Sign-in/Register to access full text options
Sign-in/Register to access full text options 
Paper version not known
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
